VMZ-A dynamic push-through anchor rods
VMZ-A dyn anchor rods, galv. steel, max. clamp. length: 25 mm, 100 M12 x 25/155
For use in dry indoor areas
Register now and access more than 125,000 products
For use in dry indoor areas
The VMZ dynamic injection system is a bonded expansion anchor for dynamic loads, consisting of a VMZ composite mortar and a special anchor rod with nut and washer. Using an application gun, both components of the VMZ composite mortar are injected into the drill hole via a mixer nozzle and the anchor rods are inserted manually. The load is transferred via the mechanical interlocking of individual anchor rod cones in the mortar and also via a combination of retention and frictional forces in the concrete.
Application area:
For anchoring:
- Lift rails
- Conveyors or cranes
- Robots
- Slewing cranes
- Heavy machinery
- Ventilators
- Noise protection walls
- etc.
in cracked and non-cracked standard concrete with strength classes C20/25 and C50/60.
Field of Application:
For use in dry indoor areas using push-through installation
Advice:
For anchoring:
- Lift rails
- Conveyors or cranes
- Robots
- Slewing cranes
- Heavy machinery
- Ventilators
- Noise protection walls
- etc.
in cracked and non-cracked standard concrete with strength classes C20/25 and C50/60.
Advantages:
- Approved for general construction for static, mainly static and dynamic loads in cracked and non-cracked standard concrete with strength classes C20/25 and C50/60
- Safety through high load-bearing capacities
- Highest dynamic loads when static and non-static loads are separated and when the actual vibration frequency is taken into account
- Standard processing with conventional VMZ chemical injection mortar (only authorised for application with this system) and quick insertion thanks to push-through installation
- Instant installation checks possible if excess mortar escapes
- Also available for cotter-pin installation on request
- Deliverable in A4 and HCR versions on request
Datasheets(X)
Type description | VMZ-A dyn 100 M12, 25/160 zinc-plated |
Required injection mortar | VMZ 330 |
Anchor diameter x anchor length (l) | 12 x 160 mm |
Nominal drill-bit diameter (d 0) | 14 mm |
Drill hole depth (h 1) | 105 mm |
Torque during anchoring (T inst) | 30 Nm |
Material | Steel |
Surface | Zinc plated |
Anchor diameter | 12 mm |
Anchor length (l) | 160 mm |
Thread diameter (metric thread) | 12 mm |
Select RAL-colour code
!! NOTE: On-screen visualisation of the colour differs from real colour shade!!
