Countersunk head screws, ISO 10642 A2
Countersunk head screws, ISO 10642 A2-70, hexagon socket 4 M6 x 25
Hexagon socket countersunk head screws
Register now and access more than 125,000 products
Hexagon socket countersunk head screws
Due to their head geometry, countersunk head screws have a limited load capacity according to this standard and may not meet the requirements for tensile or torsional strength. The actual mechanical properties of the screw are unchanged and comply with ISO 3506-1.
Depending on the type, these items are supplied with threading almost up to the head.
Countersinks for screw heads in accordance with DIN 7991 and ISO 10642 must comply with DIN 74 type F
Advice:
DIN 7991 has been withdrawn and replaced by ISO 10642. There is some limited similarity (Some head heights and head diameters changed | Nominal diameter M18, M22, M24 removed | Stainless steels removed | Strength classes 10.9 and 12.9 added).
Due to their head geometry, these screws can only be subjected to limited loads, see DIN EN ISO 3506-1
Datasheets(X)
 | |
Thread type x nominal diameter (d) | M6 |
Length (l) | 25 mm |
Thread length (metric thread) (b) | 18 mm |
Head height (k) | 3.72 mm |
Head diameter (dk) | 12.16 mm |
Width across flats (s) | 4 mm |
ISO | 10642 |
Material | Stainless steel A2 |
Thread type | Metric thread |
Nominal diameter | 6 mm |
Pitch (p) | 1 mm |
Head type | Countersunk head |
Last viewed
H1 STRAIGHT GREASE GUN CONNECTOR - WIDTH ACROSS FLATS 7 mm
EXTENDIBLE TAP WRENCH
ultra screwdriver slotted
Hand protection for chisel
Universal steering wheel covers
Dip-insulated mechanics' nippers (construction worker's pincers or end cutting nippers)
Multi-purpose anchor, without collar
Chemical anchor, without styrene
Cleaning and marking felt, roll
X FOAM foam applicator gun