LOCTITE 510 FLANGE SEALANT

HIGH-STRENGTH GASKET SEALANT

LOCTITE® 510™ cures in the absence of air when confined between close-fitting metal surfaces. The product is a general gasketing product suitable for hand dispensing or screen printing.

Pack of 12 pcs

Field of Application:

Crankcase studs; connecting rod small end bolts; gearbox bolts.

Instructions:

1. For best performance, bond surfaces should be clean and free of grease.
2. The product is designed for close-fitting flanged parts with gaps up to 0.25 mm.
3. Apply manually as a continuous bead or by screen printing to one surface of the flanges.
4. Low pressures (<0.05 MPa) may be used when testing to confirm a complete seal immediately after assembly and before curing.
5. Flanges should be tightened immediately after assembly to avoid shimming.

Clean-up
1. Cured material can be removed by soaking in a Loctite® solvent such as Loctite® 7200 and mechanical removing it with a soft scraper. Avoid formation of dust and aerosols. Complete the cleaning process by wiping with a soft cloth dampened with a Loctite® cleaner, e.g. Loctite® 7063 or Loctite® ODC-free cleaner.

Advice:

NSF International
Registered to NSF category P1 for use as a sealant where there is no possibility of food contact in and around food processing areas.
Approved by Australian Gas Association Certificate number 2590 Class II rated working pressure 500 kPa, working temperature -10 to 200°C.

This product is not recommended for use in pure oxygen and/or oxygen-rich systems and should not be used as a sealant for chlorine or other strong oxidising materials.
Where aqueous washing systems are used to clean the surfaces before bonding, it is important to check for compatibility of the washing solution with the adhesive. In some cases these aqueous washes can affect the cure and performance of the adhesive.
This product is not normally recommended for use on plastics (particularly on thermoplastics, where stress cracking of the plastic could occur). Users are recommended to confirm compatibility of the product with such substrates.